SpecificationsSingle View (from one image)
- Two dimensional distance measurements (base module)
- Plane based three dimensional distance measurements (base module)
- Front view correction from angled view (base module)
- Hole detection, hole diameter, pitch between holes (optional)
- Rod diameter, rod to rod pitch for RC structures (optional)
Two View (from two images)
- Three dimensional distance measurements (base module)
- Output three dimensional coordinates (base module)
- Hole detection, hole diameter, pitch between holes (optional)
- Reference-plate-free measurements: calculate camera position from known reference points (optional)
Notes- Reference plate is not included in the package: available at additional cost.
- For better accuracy, camera internal parameters need to
be calculated to correct distortion or nodal point
deviation, which are inherent to camera lens.
ITTC offers calibration service and calibration software:
- Calibration service - check in your camera and we will calculate camera parameters for you.
- Calibration software - various camera parameters can be calculated. - For extremely large object, please consult with ITTC: ordinary setup (i.e. one reference plate) may not work. Additional references or other methods may be recommended (e.g. calculate camera position in place of reference plate).
- Single view 3D measurements are available in not all positions/orientations.